Make your own electrical plan!

To create your electrical plan, click on the menu :

- Build

- - Power network

Add all your electrical items:

- The plugs

- The network jacks:

- The switches:

- The spotlights:

- The electrical board:

- Others:

 LINKING THE ELECTRICAL SYSTEM :

When you have placed all your electrical elements, you will be able to link them, to do this click on a light point and on "access the electrical system" in order to enter the mode again:

The icon below will allow you to link to the switch, a non-continuous line will be displayed when you hover over your electrical elements until you click on a switch:

When the link is made, the line will become continuous.

GROUPING PLUGS: 

By duplicating them, click on the icon below: 

It is therefore possible to group electrical elements at the same height, e.g. either high sockets together or low sockets.

 It is not possible to group a low socket with a high socket.

Ex: In the drawing above, you can see that the high socket is set back from the group of low sockets, which is quite normal because the sockets are not at the same height:

You can EXIT ELECTRIC MODE by clicking on "close electric system mode":

When you exit the electrical menu, you can choose not to display the electrical plan by going to 2D view, and click on "display electrical elements" to deactivate them.

When out of mode, the elements are greyed out, and when in electrical mode, the elements are coloured.

 PRINT THE ELECTRICAL DIAGRAM :

Click on the printer on the central menu:

On the 2D tab you can change the display to choose only electrical mode, it is also possible to enlarge the symbols for better visibility.